Amplifier Load Cell & Strain Gauge

Most of the load call amplifier units provide power to the sensor in addition to converting the sensor output. The 140/142 are high frequency, gain adjustable and can be matched to the sensor. The XAM is used for strain gauged based sensors to convert from a low mV output to either a voltage or current output. Cable assemblies are available to interface between the sensor and amplifier. Get in touch for and new products you are unsure about or if we can provide some extra information on the applications of our load cell amplifier devices.

Please wait, loading results...

Amplifier Load Cell & Strain Gauge

DSC digitiser module

Digitiser module for strain or load

  • Signal conversion
  • Linearisation and compensation
  • RS232, RS485, Modbus, CAN formats
  • Evaluation kit available

ICA analogue amplifier

Analogue amplifier for strain, pressure

  • Voltage supply standard 5 VDC
  • Output voltage or current options
  • Reverse polarity, short circuit protect
  • ATEX version available

SGA strain gauge

Amplifier, strain and load

  • Supply either AC or DC options
  • Output current or voltage
  • Up to 4 x 350 ohm bridges
  • 1-5 kHz filter available

AMP320 DIN Rail

Amplifier, DIN rail mount

  • Supply 14-26 VDC 
  • Output ±10 VDC
  • Bandwidth 1 to 10 kHz
  • Operating temperature 0 to +70°C

AMP330 In Line Amplifier

In line amplifier

  • Supply 14-26 VDC
  • Output 0-10V and 4-20mA
  • Frequency 1 to 10 kHz
  • Connector Binder M8 male 768-718 Series

Load More